Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before commissioning
Place the device upright on a firm, level and moisture-resistant surface. Po-
sition the device at least 10 cm away from walls to achieve optimal humidi-
fication results.
To ensure optimum performance of the unit, please make sure that the air
inlets and outlets are not covered.
Check the power cord to make sure it is not damaged.
Lift the main body off the lower housing.
Remove the packaging the evaporative element and insert the evaporative
element into the lower housing.
Place the main body back on the lower housing and make sure it is securely
and correctly seated
Fill with water through the opening, taking care not to fill with more than
the MAX water level.
Connect the power cord to a power outlet.
min. 10cm
Commissioning
1.
Power
The power switch is used to start and shut down the device.
The switch can be operated by simply pressing it.
The unit always starts in manual mode, at medium humidification level (II) and with the
ambient light switched off.
2.
fan/humidification stage
This function can be used to set the fan speed and thus the air flow rate as well as the
humidification capacity.
In order to be able to optimally adapt the air flow rate to the respective conditions, the
unit has 4 fan/humidification stages.
By repeatedly pressing the switch, the fan speed can be set from I (low) through II
(medium) and III (high) to Turbo (very high).
EN-6
min. 30cm
min. 10cm
min. 10cm
www.comedes.com
Werbung
