Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
Determining the spreading quantity
Depending on the material being spread, the size and
weight of the grains vary. Humidity influences the
grain size. For this reason, it is not possible to give
exact setting recommendations.
Manufacturer's information generally relates to 1 m².
Determine individual settings as follows:
– Unfold a newspaper approximately approximately
1 m² in size, and lay it on the ground.
– Choose a narrow setting on the spreader.
– Run over the newspaper with the spreader, meas-
ure the amount spread (e.g. on kitchen scales)
and compare with the manufacturer's recommen-
dations.
Fertiliser
Celaflor Grünkorn (green grain)
Compo Rasen Floranid
Compo Rasen Floranid with weed killer
Compo Rasen Floranid with moss killer
Compo lawn fertiliser plus guano
Cornufera Standard lawn fertiliser with long-term effect
Cornufera lawn fertiliser with moss killer
Cornufera lawn fertiliser with weed killer
Neudorff Bio Rasen Azet
Oscorna Rasaflor organic
Spiess-Urania Scotts universal fertiliser
Wolf lawn nutrient with long-term effect
Wolf moss killer plus lawn fertiliser
Wolf weed killer plus lawn fertiliser
Sand or salt
Never use unhydrated lime
Spreading
– Before loading the material to be spread, set the
lever to [0](closed).
– Load the material to be spread.
– Set the desired spreading amount by adjusting
the lever.
– Apply the material by moving at a steady walking
pace.
The material is spread when moving forwards or
backwards. However, the spreader should be pushed
wherever possible (forwards motion).
Storing, disposal, transport
Cleaning
Cleaning the machine
– Empty the spreader after each use.
– Remove any coarse dirt.
It is preferable to clean the spreader without wetting
it.
If necessary:
– Rinse the spreader out with water and let it dry.
In the case of a brief absence and of increasing wind
place the spreader in a sheltered area.
14
Setting values
As grass seeds in particular have different grain sizes
according to type and moisture content, a binding
general setting for grass seeds is not possible.
Please however remember that if you make one pass
lengthways across your lawn surface, and one pass
crossways, double the amount is applied.
Setting guidelines
• Lawn seed 2–3
• Fertiliser 3–4
Spreading table
The following table serves as a guideline, and
because of the multiplicity of manufacturers and
products cannot be complete.
Lever setting
1
2
•
•
•
depending on grain size
Maintenance
– Regularly check the connections.
Storing
– The product is sensitive to frost. Store the product
for the winter where it is dry and well ventilated.
Malfunctions and troubleshooting
DANGER! Attention, danger of injury!
Improperly conducted repairs may prevent
your product from working safely. Such
repairs will endanger you and your sur-
roundings.
If you are unable to correct a fault yourself, please
contact our technical support directly. Please note
that improperly conducted repairs will void your rights
under warranty and may cause you additional
expenses.
Disposal of excess material for spreading
Excess material should be given back in the original
packaging. Spreader material should not come into
the environment in an uncontrolled manner. Its dis-
posal should comply with local authority require-
ments.
3
4
5
6
7
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
8
Werbung
