TecTake 405156 Bedienungsanleitung Seite 5

Warning:
DO NOT USE SHARP TOOLS AND OBJECTS!
ANY USE OF AIR GOMPRESSORS WILL DAMAGE YOUR PRODUCT AND VOID ALL WARRANTIES.
ONLY USE THE PUMP INCLUDED IN THE SCOPE OF DELIVERY.
FOR FIRST INFLATION, IT IS RECOMMENDED TO INFLATE INDOOR AT ROOM TEMPERATURE WHERE
THE BOARD MATERIAL IS SOFT AND THE ASSEMBLY PROCESS IS EASIER.
Choose a smooth and clean surface to unfold your product.
ALWAYS WEAR A LEASH WEHN PADDLING!
IF THE BOARD IS EXPOSED TO THE HOT SUN, CHECK THE PRESSURE AND MAKE SUR IT'S NOT
OVERPRESSURED.
DEFLATE SLIGHTLY IF NECESSARY.
INFLATION
1) The board is equipped with a high-pressure valve. To inflate, first open the cap by turning it counterclockwise.
Check and make sure
the valve is in closed position. To verify that, push the pin down. If the pin stays down, you have now opened the
valve. To close it, push
the pin again so it springs back up. Now the valve is closed. Inflation is done in the CLOSED position (pin UP),
and deflation is done in the
OPEN position (pin DOWN).
2) The pump has two ports: the OUT port and the IN port on the handle. The OUT port is for inflation, and the
IN port is for deflation.
Attach one end of the pump hose to the OUT port, and the other end to the high-pressure valve. Push the hose
fitting into the 'valve
and turn clockwise to lock the position. Inflate until the desired pressure is reached the recommended pressure
(12 to 15 psi). After
inflation, disconnect the hose and close the cap. The valve won't be airtight until the valve cap is closed.
3) Read the instructions on the pump body about single action pumping and double action pumping. First pump
in double action mode to
generate large volume of air at low pressure. When you feel pumping becomes heavy, switch to single action
and inflate to the desired
pressure. Check board pressure with the gauge on the pump. Do not over-inflate the board. The recommended
pressure for typical use is
12 to 15 psi.
DEFLATION
To deflate, open the valve cap and push the valve pin down to open the high pressure valve. When the air fully
come out, push the valve and then close the cap.
STORAGE
1) Clean and check the board and all the accessories after each use. Rinse it thoroughly with clean water and
make sure to remove any
residues or salt if used in salt water. Do not use detergents or any type of silicone-based products. Make sure
the product is completely
dry before putting away.
2) Roll it up from the tail. Put it into the backpack. Rolling from the tail can contain the fin boxes and clips inside
the wrap, which will
provide better protection than exposing them to the outside.
3) When storing your board, keep it in a clean and dry place that is not affected by major variations in temperature
and other damaging
factors. You may store it. Deflated and rolled up in a bag or assembled and lightly inflated (not subject to
deformations). Store it away
from rodents.
EN
5