Charging Process - Spokey Rino+ Handbuch

EN
SPECIFICATIONS:
Battery
Charging time
Voltage
Capacity
Working Temperature
Charging Temperature
Storage Time (-200C - 250C)
Storage Humidity

CHARGING PROCESS

• Ensure charging port is dry.
• Open the charging port. Plug the charging cable into the Aero Electric
Scooter, then connect the cable with the power supply (100V~ 240V; 50,
60 Hz). The red light indicates that it has begun to charge, otherwise check
whether the cable is connected.
• When the indicator light goes from red to green, it indicates that battery
is fully charged. This takes approximately 3 hours. Stop charging when
the LED turns green; charging the battery for too long time will reduce its
lifetime.
• The protective cover is used to protect the charging port from splashing
water or dust. Be sure to replace the cap after each charging and before
each use.
• Only use the charger supplied with your electric scooter. Using a charger
other than supplied will invalidate the warranty.
• To optimize the performance and lifetime of your electric scooter battery,
fully charge the battery before using it for the first time and fully charge it
every three months..
• Do not cover the battery compartment or the charger. There must be good
ventilation conditions at all times during charging.
• The charging environment must be clean. Ensure there are no traces
of damp or water in the electric socket before plugging in.
• Ensure you use a standard socket.
8
Akumulator litowy
3-4h
36 V
7,5 AH
-150C ~ 500C
00C~400C
112 months
5% - 95%
www.spokey.eu
Parameters