Spokey RINO+ Handbuch Seite 4

EN
ASSEMBLY
Step1.
Raise the stem to the maximum and slide down the Stem Clamp.
Step3.
Unscrew the bolt, connect the Main Cable
together (please align the male port
and the female port carefully), insert the
handlebar into the stem, screw in the bolt
and then tighten it with two Hex spanners
completely.
Note:
Please ensure that the hole is not blocked by
the cable when you screw in the bolt.
4
Step2.
Close the two levers until the Stem Clamp is closed completely
Note:
If the clamp is not tight enough, please open the levers, tighten
the bolts slightly with your thumb and forefinger (or Allen
wrench), then re-closes the levers. Repeat until some effort is
needed to close the levers all the way.
www.spokey.eu