Fault Code; How To Ride - Spokey Rino+ Handbuch

EN
Speed Meter:
display the real-time speed.
"S": Speed Level
Level1- the maximum speed is 6km/h.
Level2-the maximum speed is 15km/h.
Level3-the maximum speed is 20km/h.
Note: Level1 is pedestrian mode. Under this mode, the maximum speed is 6km/h, and the rear lights are flashing.
Battery Indicator: each bar means 20% of the full battery capacity
Power Key: It is a muti-functional button
-Long press it to turn on/off the scooter.
-Short press it to turn on/off the front light and rear light.
-Double press it within 1 second to switch between different speed levels.

Fault Code

Code
E1
E2
E3
E4
E5
E6
E7
GUIDE FOR SAFE RIDING

How to Ride

• Turn on the scooter by long press the Power button on the
Meter.
• Put one of your feet onto the footplate, kick the scooter to
give it a minimum speed of 5km/h, and press the accelerator
simultaneously, then it runs.
6
Code
There is an issue with the accelerator
There is an issue with the hall for decelerator
The battery level is too low
There is an issue with the controller
There is an issue with the hall for motor
There is an issue with the transmission of the meter
There is an issue with the transmission of the controller
• If you want to slow down the speed or stop, please press the
hand brake lever with your hand
• The scooter will be powered off automatically when it stays
inactive for 3 minutes.
www.spokey.eu