Manual Setting - Chunghop Rm-88E Bedienungsanleitung

Setting Steps for TV Set
Manual Setting
1.Find out the 3-digit code for the TV that you
desire to control from the "code list" .In case
Search code 4
there are several groups of codes available,
y
please use the first group at first;
2.Press and hold the "Setting" button at first, Press and hold [Setting] + | TV
then press the "TV" button. Release both the "Setting"
shall commence. 5
Setting ends
Search For the Correct Code
In case that your TV cannot be remotely controlled after all the codes available are tried, or
in case that your TV is the brand that has no matching code in the "code list" , you may
try the following steps:
1.Manually switch o the TV that you desire to control,it should be in playing state
2.Aim the remote controller at the TV. Press and hold the "Setting"
button at first, then press
the "TV" button. At this time, the indicator light illuminates. Then release both buttons.
3.Press the "Volume Up" button on the remote controller and release it to observe whether
the volume indication on the TV is shown. Repeat the operation till the volume indication on
the TV is shown, and then press the "Setting" button.
Note: Each press of the "Volume Up"
button will lead to one code emission. If the code is
identifiable by the TV, the volume of the TV program will change.
4.At this time, the indicator light extinguishes, and the setting ends. You can check other
functional buttons, for example, "Power" to ensure that they work well.
5.In case other buttons fail to work properly, a resetting started from Step 2 shall commence till
the correct code is found.
Note: After each press of "Volume Up" button, the code number of the remote controller will
add 1 and the "Volume Up" code under the code will be emitted once. In case a normal
control still cannot be obtained, please refer to the "Problem Solving" .
Setting Steps for VCD Machine
Manual Setting
1.Find out the 3-digit code for the VCD machine
that you desire to control from the "code list" .
In case there are several groups of codes рз Sd Hold JSearch cedo
available, please use the first group at first; the "Setting"
2.Press and hold the "Setting" button at first, button, then y
indicating the status of code input; Indicator light illuminates
3.Input sequentially the 3-digit code that you
have obtained. The indicator light flashes Release both buttons
once when one digit is input. After the input E 1
of the code, the indicator light extinguishes; Input the
Note: In case the indicator light keeps 3-digit code. (9 (9 (9
illuminating after two flashes, you only need y
to input the correct 3-digit code and do not Indicator light extinguishes
repeat Step 2, otherwise a resetting started > { Yes
from Step 2 shall commence. Setting ends
4.When the indicator light extinguishes,the setting ends.Please test the remote control can work
normally ог not,if not, reset it from step 1 and try next 3-digit code