EDIFIER W800BT SE Bedienungsanleitung

Wireless Over-Ear Headphones with Active Noise Cancellation
EN 1. Power ON/OFF
Press and hold the power button to power on/off.
2. First pairing
1. Once powered on, the headphones will automatically enter
Bluetooth pairing mode.
2. Select "EDIFIER W800BT SE" from your device list to connect.
3. Pairing for new device
1. In ON state, press and hold the "
enter Bluetooth pairing mode.
2. Select "EDIFIER W800BT SE" from your device list to connect.
Note: For subsequent use, the headphones will automatically connect to the device used last time.
4. Multipoint connection
①
②
③
Bluetooth
EDIFIER W800BT SE
1. Pair device A with the headphones successfully.
2. Press and hold the "
pairing mode, and then select "EDIFIER W800BT SE" in device B
settings to connect.
3. Select "EDIFlER W800BT SE" again in device A settings to connect,
and the multipoint connection is done.
Note: For subsequent use, the headphones wil automatically reconnect to the two devices used
last time.
5. Charging
Connect the headphones to a power source via the USB-C cable for
charging.
Note: 1. Make sure the USB-C port is completely dry before charging.
2. When charging with a USB-C cable, the product is used as wired headphones and
Bluetooth functions are unavailable.
6. Controls
● Call
● Music
● Mode
Note:
1. "x 1" Press , "x 2" Double press, "x 3" Triple press, "—" Press and hold;
2. Download EDlFlER ConneX App for more customizable control settings.
7. Reset
1. In ON state, press the "
2. The headphones will automatically enter Bluetooth pairing
mode if successful.
8. Wired listening
Connect to the headphones via the USB-C cable. Wired listening will
automatically disable Bluetooth mode.
W800BT SE
Model: EDF200173
Manual
A
" button for 3 seconds to re-enter Bluetooth
x1
x1
x2
x1
x1
x3
x1
x1
ON
OFF
Bluetooth
EDIFIER W800BT SE
3s
Bluetooth
EDIFIER W800BT SE
" button for about 3 seconds to
x6
" button 5 times to finish reset.
1s
-
1s
-
Bluetooth
EDIFIER W800BT SE
A
B
Input: 5V
x5
1A