REPTIL'US DTH Control Bedienungsanleitung Seite 7

Symbols :
Display: cool working; no display: cool stopped working.
Display: heat working; no display: heat stopped working.
Display: humidification working; no display: humidification stopped working.
Display: dehumidification working; no display: dehumidification stopped working.
Display: daytime; no display: nighttime.
Display: nighttime; no display: daytime.
Rapid flash: high temp alarm or low temp alarm
Rapid flash: high humidity alarm or low humidity alarm.
Temperature Selection Menu :
Modes
HEAT/ COOL MODE
Day temperature (SET)
Night temperature (SET)
DIFFERENCE
ALARM
Humidity Selection Menu :
Modes
HUMI/ DESHUMI MODE
Day humidity (SET)
Night humidity (SET)
DIFFERENCE
ALARM
Parameters setting :
For first-time use, parameters would be set in the following order. All parameters are saved instantly.
First of all, make sure the power is on.
1) Choice of mood : HEAT or COOL
RT (real-time temperature)
Press on "SET" for 3 seconds to select the mode.
When "HEAT" flashed, press "UP" or "DOWN" to choose between "HEAT" and "COOL".
2) DAY SET : day temp setting
Press on "SET'", "Default temperature" appears on the display while ""DAY SET" is flashing. Press "UP" or
"DOWN" to adjust the ideal temperature.
3) NIGHT SET : night temp setting
Press on "SET'", "Default temperature" appears on the display while ""NIGHT SET" is flashing. Press "UP" or
"DOWN" to adjust the ideal temperature.
4) DIFFERENCE (for temperature)
Press on "SET'" until the "DIFFERENCE" symbol flashes and the display shows the current value. Then press
"UP" or "DOWN" to adjust the ideal temperature difference.
Parameters Default values
HEAT/ COOL HEAT
16~42°C 30°C
16~42°C 22°C
0.1~9.9 2.0°C
1~10 5.0°C
Parameters
HUMI/ DESHUMI
1~99%
1~99%
1~20 %
1~30 %
Notes
COOL mode delay after 1min.
0.1°C graduation
0.1°C graduation
0.1°C graduation
/
Default values
HUMI
50% 1% graduation
60%
5%
10%
Notes
/
/
/
/
6