Hama Boom Clock Bedienungsanleitung Seite 4

Setting the time and date
Press and hold the clock set button until the digits on
the display flash
At this point choose whether you would like 12 or 24
hour clock. Press VoI + (C) to switch between either
Option press set (E)once happy
• Now the hour digits will be flashing press the V014/
Vol buttonsto setthe hourthen pressset (E)to move
Follow the same process as above to setthe minutes /
year / month / day Ofmonth / day of weak
• You have 10 seconds to do something at each stage
before the „KitSound Boom Clock"leaves the set mode
automatically
Setting the alarm
• Press the Alarm/ sleep button (G)
• press the source button (B)to choose between:
iPod mode / FM mode / Buzzer mode
• Usethe volumeup/ down buttons(C/ D)to setthe
volume needed to rouse you from your slumber
Press the alarm / sleep button again to choose between:
5 Day alarm setting the alarm will just go off Monday to
Friday and leave you in peace on the weekend
7 Day alarm setting This one will go off every day. No
rest for the wicked..
REMEMBER - NO BELL ON THE DISPLAY
NO „KitSound Boom Clock" WAKING YOU UP
Now press the Set / Preset button (E)
• The hour digits will be flashing
• Usethe VoI+1VoI- buttons(C/ D)to adjustto suit
Pres Set/ Preset
• The minute digits will be flashing
• Use the Vol + / Vol —buttons (C/ D)to adjust to suit
• Pres Set/ Preset
ALL SYSTEMS GO!!
Note - if you set the alarm to iPod and do not have an
iPodin the dock,the BoomClockwill wakeyou upwith
the buzzer.
Rocking the „KitSound Boom Clock"
All of the following operations can be done on the remote
as well asthe buttons on top of the unit.
Using the radio
Turn the Boom Clock on using the Power Button (A)
• Press the Source button (B) until the FM icon is
displayed
6
Tune into your desired station using the tune + /
buttons (J / K)
• Crank
To set a preset
• Tune into desired station as above
• Press and hold the Set/ Preset button (E)
• 'Pl' will be flashing on the display
Use the volume + / buttons (C/ D) to select which Of
the 6 available presets you want to set the station to
• press the Set/ Preset button (E)once
To jump to a preset station when in FM mode:
• Press the Set/ Preset button (E)once
• Pressing again will cycle up though the 6 presets
Listening to your iPod/iPhone
• Connect your iPod / iPhone to the Dock
Make sure Power is on
Make sure you have selected iPod mode using the
source (B) button
Select some tunes
• Press play
Adjust volume to suit using VOI+/ buttons (C/ D)
Don't be shy, give it some beans
You can navigate the iPod menu system using the
remote control
Menu (K on remote)cyclesthoughthe menusystem
• The Up and Down (H/ on the remote) moves the
highlighted selection up and down
The Select button confirms your selection
Using the Auxiliary input
Connect your equipmentto the Aux jack on the rear Of
the Boom Clock
Makesure youare rockingAuxmodeusingthe source
(B) button
• Crank it
Adjust the output volume Ofyour device so that the
„KitSound Boom Clock" is getting a decent signal
(nottoo loudsothat youget distortion/ not too softthat
you don't get enough volume)
Specifications:
• Total7Woutput(2Wx2/ Satelite+3Wfor sub-woofer)
• THDCIO%
SIN ratio:
Frequency Response: 100Hz 16k Hz
• Mains adapter: 5VDC@2A
Safety/Care:
DO not allow the KitSound Boom Clock to be immersed
or even splashed with water. It is not waterproof.
DOnot expose the KitS0und Boom Clock to extremes of
temperatures.
• Donot attemptto openthe KitSoundBoomClockupto
get inside, there are no user serviceable parts and you
will have invalidated your warranty
Do not change or modify the KitSound Boom Clock
unless you accept that doing so invalidates your
warranty
Clean the KitSound Boom Clock only with a soft dry
cloth. Do not use any abrasive cleaners.
7