Ronix RP-0101C Bedienungsanleitung Seite 19

NOTE:
The machine not suitable for connection to the potable water main.
WARNING!
The intake water temperature must not exceed 40. The water supply
must not exceed 7 Bar .
CAUTION:
The washer must only be used with clean water; use of unfiltered water
of corrosive chemicals will damage the washer.
- Push the motor switch to "OFF" position.
Check the electrical supply voltage and frequency (Volt/Hz) correspond
to those specified on the washer rating plate. If the power supply is
correct, you may now plug in the washer.
OPERATION
- Turn on the water supply tap fully.
- Release the safety lock then press the trigger for a few seconds to
allow air to escape and discharge residual pressure in the hose.
- Keeping the trigger pressed push the switch to start the motor.
17
User Manual