Camera Introduction; Connection Diagram - Redlink Rlc-81Pa Bedienungsanleitung

Camera Introduction

1
2
3
4
5
6
7
3
Spotlight
1
Lens
2
IR LEDs
3
Daylight Sensor
4
Micro SD Card Slot
5
Speaker
6
Adjustment Knob
7
Waterproof Lid
8
Network Cable
9
Reset Button
10
* Press for about 10 seconds to
restore the device to factory
settings.
Power Port(Optional)
11
8 9 10 11

Connection Diagram

Before using the camera, please connect your camera as instructed
below to finish initial setup.
1. Connect the camera to a Reolink NVR (not included) with an Ethernet cable.
2. Connect the NVR to your router, and then power on the NVR.
NOTE: The camera should be powered with a 12V DC adapter or a PoE powering device such as
PoE injector, PoE switch or Reolink NVR (not included in the package).
Power Adapter
Reolink NVR
OFF ON
AUDIO
DC 48V OUT USB HDMI
* You may also connect the camera to a PoE switch or PoE injector.
PoE IP Camera
Router
1 3 5 7
eSATA
VGA LAN 2 4 6 8
Ethernet Cable
Ethernet Cable
4