GET BOOST Handbuch Seite 4

C. GET BOOST INSTALLATION
REMEMBER TO OPERATE IN SAFE CONDITIONS AND KEEP THE ENGINE OFF.
1.
Remove the seat and
position the GET wiring under
the frame crossmember,
keeping the main connector
(A) oriented towards the rear
fender.
2.
Insert the GET Boost
module into the dedicated
rubber mount provided in the
kit. Connect the main GET
wiring connector (A) to the
GET Boost connector.
3.
Locate the original relay
under the seat.
disconnecting or removing it
from its rubber mount, detach
the relay from its metal
mounting tab. Install GET
Boost in its place, fastening
it to the original metal tab.
Secure the relay to the GET
Boost module with a zip tie.
Without
4
A
Towards
the rear
fender
A
EN