Werbung
Verfügbare Sprachen
Verfügbare Sprachen
This may be done using an in-line oiler, or manually.
If done manually, proceed as follows:
1.
Disconnect the tool from air supply. (Fig.6)
2.
Place a few drops of air tool oil into the air inlet. (Fig.7)
Note: Avoid the misuse of thicker oil which may lead to the
reduced performance or malfunction.
3.
Connect the tool to the air supply. Run the tool without load for a
few seconds to distribute the oil through the tool.
Note: Any excess oil may be propelled from the chuck area.
So keep the tool away in a safe direction.
4.
After operating the tool and before storing the tool, disconnect
the air hose and place 4 or 5 drops of air tool oil into the air inlet,
then re-connect the air hose and run the tool to evenly distribute
the oil throughout the tool for 30 seconds approximately.
This will prolong the tool life.
5.
Avoid storing the tool in a humid environment which promotes
rusting of internal mechanisms.
Always oil the tool before storage.
6.
When the tool is seriously damaged or out of life, it should be
left in a resource recycling can. Never drop it into fire.
TROUBLESHOOTING
Problem
Tool runs slowly
or will not
operate
Abnormal
vibration or
excessive heat
NOTE: For any special troubles which cannot be settled down by the operator, contact the distributor
or sales agent from whom you purchase the tool.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Possible Cause
1. Flush the tool with air-tool oil or gum solvent.
2. Lubricate the tool according to the lubrication
3. Adjust the regulator on the tool to maximum setting.
1. Grit or gum in
4. Adjust the compressor regulator to tool maximum of
tool.
2. No oil in tool.
5. Tighten and seal hose fittings if leaks are found.
3. Low air
6. Use sealing tape.
pressure.
7. Be sure the hose is the proper size. Long hose or
4. Air hose leaks.
5. Pressure
drops.
6. Worn rotor
8. Do not use a multiple number of hoses connected
blade.
7. Moisture
blowing out of
tool exhaust.
9. Replace rotor blade.
10. Water in tank: drain tank. (See air compressor
Improper
lubrication
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Corrective Action
instructions in this manual.
90 PSIG.
tools using large volumes of air may require a hose
with an I.D. of 1/2 in. or larger depending on the total
length of the hoses.
together with quick-connect fittings. This causes
additional pressure drops and reduces the tool
power. Directly connect the hoses together.
manual). Oil tool and run until no water is evident. Oil
tool again and run 1-2 seconds.
Follow proper lubrication procedures in this manual
Fig.7
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Werbung
