Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PACKAGING CONTENTS
Description
Air Knife
Blade
Wrench
Manual
Male Plug
PREPARATION
Before beginning assembly or operation of the product, make sure that all parts are present.
Compare the parts with the package contents list. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact the distributor or sales agent for replacement.
OPERATION INSTRUCTIONS
1.1. Disconnecting the air supply
,lubricate the tool before
operating. See "CARE AND
MAINTENANCE" section for
oiling instructions.
1.2. Loosen the hex screw with
wrench (Fig.)
1.3. Assemble blade with camber
surface upward.
(Fig.2)
1.4. Re-position the hex screw and
tighten with wrench.
(Fig.3)
WARNINGS
Only use accessories that have an
RPM rating equal to or greater than
the tool itself
1.5. Remove the air cap from the
tool air inlet and connect the
air supply hose to the tool. Set
the air pressure at 90 PSI.
(Fig.4)
1.6. Push forward the throttle lever
lock and press down on the
throttle lever. How far the
throttle lever is pressed
determines the tool rotation
speed. Then the tool starts to
work. (Fig.5)
CARE AND MAINTENANCE
The tool should be lubricated daily (or before each use) with air tool oil (not included).
Note: Air tool oil is available at major tool hardware stores.
SAE #10 weight oil or sewing machine lubricant or any other high grade turbine oil containing
moisture absorbent, rust inhibitors, metal wetting agents and an EP (extreme pressure) additive may
be used as a substitute. Do not use detergent oil.
During continuous operation, the tool should be oiled every 1 to 2 hours.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Quantity
1
1
2
1
1
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Fig.1
Fig.3
Fig.5
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Fig.2
Fig.4
Fig.6
Werbung
