Stramatel 452 MB 7120-2 Montageanleitung Seite 10

Multisport
Scoreboard installation
In order to make installation easier, anchor points (I) are available on the top side of the scoreboard (insert holes in aluminium frame).
Screw-rings, type M6x40 (not supplied) can be screwed into place in each hole.
Each module is noted with a sticker Mxx. Please strictly follow the below instructions.
Unscrew and slide out the plastic corner shields (C) of the scoreboard. Take the connectors (Y) out of the modules.
Put the module M1 into place on the wall or on the support frame and screw in Ø 8 mm screws.
Module M2 - Mains cable port: remove one of the grommets (K) of the module and take the connector (S) out through the cable port.
If needed, connect the mains cable at the back of the module (see chapter "Electrical installation" – "Mains cable").
Put the module M2 above the module M1 and screw in Ø 8 mm screws.
Modules M3 & M4 - Mains cable port: remove one of the grommets (K) of the module and take the connector (S) out through the cable
port. If needed, connect the mains cable at the back of the module (see chapter "Electrical installation" – "Mains cable").
Put the modules M3 and M4 on one or the other side of the modules M1 and M2 and screw in Ø 8 mm screws.
Plug in the connectors (Y) between the modules.
S
I
K
C
K
M3
C
ZI de Bel Air 44850 LE CELLIER FRANCE
IA452MB7120-2_A - Installation 452MB7120-2.docx
Pro Range
Y S
I
K
C C
K
C
C
C
C
I
C
M2
C
C
M1
C
stramatel@stramatel.com Tél. +33 (0)2 40 25 46 90
Y S
I
K
C
C
K
M4
C
C
Page 5