Tip-Over Protection; Remote Control; Mobile App Control; Downloading The App - Siguro Sgr-Hs-R450B Bedienungsanleitung

EN
Setting horizontal oscillation
Press to turn on horizontal oscillation. The heater will oscillate.
Press again to turn off the horizontal oscillation function.

Tip-Over Protection

The heater is equipped with a tip-over safety guard. When knocked over, it will auto-
matically switch off and go to standby.

REMOTE CONTROL

The buttons on the remote control correspond to the buttons on the control
panel. The remote can be used instead of the control panel to perform any of the
configuration tasks described above.
The remote control is supplied with inserted batteries from the manufacturer. To use
the remote control, remove the protective film from the battery compartment. It
protects the battery from discharge and damage during transport.
If you want to use the remote control, point it to the signal receiver on the appliance.
The maximum range of signal sent from the remote control is 6 m. If obstacles are
located between the remote control and the appliance, the signal cannot be trans-
mitted.
If the inserted battery is empty it needs to be replaced by the same type. Proceed as
follows:
1. Slide the cover with the battery compartment from the bottom of the remote
control.
2. Remove the depleted battery and insert a new CR2032 battery. Observe correct
polarity when inserting a battery.
3. Insert cover with the compartment back into the remote control.
If you will not use the remote control for a long time, we recommend removing the
battery. If the battery leaks into the interior of the remote control, it could damage it.
Warning:
Never put batteries in fire, short circuit or damage them in any way.
After the end of their lifetime, discard them in environmentally friendly
manner. Never dispose of batteries in household waste.

MOBILE APP CONTROL

The appliance can also be controlled through an app from a smartphone or tablet.

Downloading the App

Download and install the Tuya Smart app. A QR code is provided for this purpose
1.
on one of the preface pages of this manual.
2. The fan can only communicate over Wi-Fi at 2.4 GHz. If your router is equipped
with 5 GHz Wi-Fi, make sure to have it set to 2.4 GHz mode.
3. Create an account and log into the app.
4. The app has a step-by-step wizard to help you with installation, registration and
login.
EN - 12