Reolink D340P Betriebsanweisung Seite 7

For the WiFi Version:
Step 3
Run the power adapter through the mounting plate and the hole on the
wall to connect it to the doorbell, then attach the doorbell to the plate.
Step 4
Plug the power adapter into a socket near the door. Use the long power
extension cable if the socket is too far away from your doorbell.
11 English
NOTE: Reolink Video Doorbell PoE&WiFi can also be powered by the
existing doorbell wiring system. In such case, you are required to first
bypass the existing mechanical chime with the jumper cable to get
sufficient power. Without sufficient power, the doorbell may restart and
has an unstable connection, and the mechanical chime may vibrate
and generate noise.
If the wire is not long enough, use the extension cable, as shown below.
After the installation, the existing mechanical chime will not ring anymore.
Use the extension cable to extend the length of the existing power cable
for the doorbell, as shown below.
Doorbell Transformer
AC Neutral
Extension cable
Mechanical Chime
Ground
Rear Trans Front
Jumper cable
English 12