BEFORE THE FIRST USE
•
Take the appliance and accessories out of the box. Remove the
stickers, protective foil or plastic from the device.
•
Before using your appliance for the first time, wipe off all
removable parts with a damp cloth. Never use abrasive products.
•
Connect the power cable to the socket. (Note: Make sure the
indicated voltage on the device matches the local voltage
before connecting the device. Voltage 220V-240V 50-60Hz.).
•
Make sure the jar is attached to the motor unit by placing the jar
on the base and turn it clockwise to connect. You can experience
some resistance when you connect it for the first time, which is
normal.
USE
•
As soon as the half citrus fruit is pressed onto the juice cone, the
motor will be activated.
•
The juice is collected in three different ways as below.
–
The spout must be positioned down to collect the juice in an
external cup or glass.
–
The spout must be positioned up to collect the juice in the
juice jar below the juice tray.
–
The spout must be placed horizontally to collect it in the juice
tray.
•
Do not exert too much pressure on the juice cone. If the sound of
the motor increases significantly or the motor itself slows down
dramatically, this means too much pressure has been exerted.
•
Please do not run the juicer for longer than 15 seconds without
interruption, please take a break for 20 minutes after pressing 20
pieces of oranges.
•
The juicer jar (1 litre capacity) can be stored in the refrigerator
with the lid provided.
•
For the best results, hold the halved fruit on the top of the juice
cone, slightly slanted towards the handle, then press down gently
to activate the motor. This way the fruit will be perfectly juiced.
•
Note that this appliance is equipped with an overheat protection
which will turn of the device when the temperature gets too high.
Once the appliance is cooled down, the thermostat will
automatically be reset.
•
Note This item is made with natural material Bamboo. It may be
that there is a small unevenness or tear in the bamboo. This is
inherent in the use of natural materials.
CLEANING AND MAINTENANCE
•
Unplug the appliance. Use a soft, slightly damp cloth to wipe
appliance surfaces. Do not allow water or any other liquid to get
into the unit.
•
Components that have come into contact with food can be
cleaned in soapy water.
•
Do not use any abrasive detergent or steel wool to clean the
appliance, as it may scratch the surfaces.
•
Some components are suitable for cleaning in a
dishwasher(Please check in the parts list for specifications).
•
The pressure section of the handle can be easily assembled for
cleaning.
Instruction manual
EN
5