Panasonic EY37C2 Bedienungsanleitung Seite 10

WARNING
LED lights create heat whilst in use.
Heat may be trapped and cause an
accident.
• Do not cover the LED lantern with cloth or
paper during use.
• Do not touch the LED lights during use or
just after the use as they become hot.
• Do not use any other battery pack besides
as shown in the Specifications.
CAUTION
1. This LED Lantern is not waterproof.
• Do not use it in damp or wet locations.
• Do not expose it to rain or snow.
• Do not wash it in water.
• Keep it in a safe, dry, and clean area when
it is not in use.
2. The LED Lantern automatically goes off when
the battery voltage drops below a specified
level.
3. Do not disassemble the LED Lantern.
Servicing should be performed by an
authorized service center.
4. Do not throw the battery pack into a fire.
This can cause an explosion.
5. Do not look into the LED light and do not
allow the lights to contact the eyes directly.
If the LED lights contact the eye continuously,
it may result in injuries to the eyes.
WARNING
• Do not use other than the Panasonic battery
packs that are designed for use with this
rechargeable tool.
• Do not carry or store the battery pack in the
same container as nails or similar metal
objects.
• Do not dispose of the battery pack in a fire,
or expose it to excessive heat.
• Do not drive the likes of nails into the battery
pack, subject it to shocks, dismantle it, or
attempt to modify it.
• Do not allow metal objects to touch the
battery pack terminals.
• Do not charge the battery pack in a high-
temperature location, such as next to a fire
or in direct sunlight. Otherwise, the battery
may overheat, catch fire, or explode.
• Never use other than the dedicated charger
to charge the battery pack. Otherwise, the
battery may leak, overheat, or explode.
• After removing the battery pack from the tool
or the charger, always reattach the pack
cover. Otherwise, the battery contacts could
be shorted, leading to a risk of fire.
• When the Battery Pack Has Deteriorated,
Replace It with a New One.
Continued use of a damaged battery pack
may result in heat generation, ignition or
battery rupture.
IV. ASSEMBLY
1. To connect the battery pack; (Fig.1)
Line up the alignment marks and attach the
battery pack.
• Slide the battery pack until it locks into
position.
2. To remove the battery pack:
Push down the button and slide the battery
pack forward.
3. Shoulder strap:(Fig.2)
Follow the step to make the loop at the
buckle. Make sure the strap is firmly fixed on
the LED lantern.
- 10 -