Selectrix Trix 66843 Bedienungsanleitung Seite 8

Second Selectrix Data
Each processing channel (address) of the central unit
can be used either to run a locomotive
turnouts, uncouplers, semaphores or color light signals,
etc. or to detect track occupancy of 8 areas of track
(blocks, station tracks).
If on larger model railroad layouts the 104 channels
(addresses 0 to 103) of the Central-Control 2000 or the
112 channels (addresses Oto 111) of the Central Unit I
or II are not sufficient to operate locomotives and acces-
sories and detect occupation
provides a second set of 112 processing channels
through a second, synchronized Selectrix data bus.
These processing channels (addresses Oto 111 on the
second data bus) are not available for running loco-
motives. They allow, however, to connect and operate
turnouts, signals, uncouplers, etc. and to detect the occu-
pation of track areas through the appropriate input and
output devices (controllers, Function Decoders, Track
OccupancyDetectors,track diagram control board with
Encoder A and B, Computer Interface).
There is no data exchange between the processing
channels of the data bus of the central unit and the data
bus of the Translater. The system status central unit on
or off, however, is fed into the second data bus.
Wiring Diagram
Operating accessories and
track occupancy detection:
Data bus Sx-2
to additional accessory
controllers, Function Decoders,
Track Occupation Detectors,
Computer Interface, etc.
Opera ng locomotives:
Data bus Sx-l to other
controllers and
Computer Interface
Central-Control
AC transformer
e.g. Märklin 6002 2000
8]
Bus
or to control 8
of tracks, the Translater
Occupation
1st Data bus
Sx-l for
o ives
Lok P-08
on
33
Controller:
e.g. Lok-Control 2000
If all devices for operating accessories and for track
occupation detection are connected to this second
data bus, all channels on the central unit are available
for operating locomotives.
Connecting the Translater to the Central Unit
The sx socket of the Translater is connected to the sx
socket of the Central-Control
of the Central Unit I or Central Unit II, using the
5-conductor DIN-plug bus cable included with the Trans-
later, if required by means of a Selectrix 4-Way Bus
Connector (66586).
All controllers for locomotives,
Computer Interface, are connected to the data bus
of the central unit.
Connecting to the Second Selectrix Data Bus
All controllers for accessories,
Track Occupation Detectors and display
including Computer Interface, if required, are con-
nected to the Translater, Socket Px (Selectrix data
bus 2, Sx-2).
Setting the Mode of Operation
The rear wire jumper (pin 1) on the adjustment block
must be inthe open position,the frontwirejumper (pin2)
must be in the closed position.
Function
Detector
2nd Data
Sx-2 for
accessories
Translater
Accessory controller:
e.g. Lok-Control 2000
Illustrations and technical data subject to change.
All rights reservedregarding changes and errors.
2000 or to the data bus
also including a
Function Decoders,
devices,
Decoder
bus
Data bus Sx-2:
to other accessory
controllers, to track
diagram control board
with Encoder A and B,
to Function Decoders,
Occupation Detectors
and Computer Interface