Skandika Rian Bedienungsanleitung Seite 12

12
SET-UP AND USE
STEP 3: USE WITH MOSQUITO NET
1. Push the aluminium rods through the rod tunnels.
2. Secure the aluminium poles on both sides in the metal eyelet (see Fig. 6).
3. Tie the tent line to the loops and anchor it to the ground (see Fig. 7).
4. Pull the tent ropes tight so that the hammock no longer wobbles (see Fig. 8).
Fig. 6 Fig. 7
Fig. 8
STEP 4: FITTING THE COVER
1. Place the cover on the hammock. Make sure that the opening on the cover and the opening on the mosquito net are on the
same side.
2. Connect the plastic clip to the hammock on both sides. The length can be flexibly adjusted (see Fig. 9).
3. Connect the cords on the inside of the tent to the aluminium poles (see Fig. 10).
4. Connect the flysheet on both sides with the carabiner (see Fig. 11).
5. There are two cords at both ends. Please close these tightly to prevent moisture from penetrating (see Fig. 12).
6. The entrance to the cover can be rolled up and secured if necessary (see Fig. 13).
Fig. 9 Fig. 10
Fig. 11