Furuno NAVpilot-711C Kurzanleitung Seite 2

Response feature
The response feature provides for simple setting of the NAVpilot's parameters to counter the
effects of wind, etc. Normally, use the auto response feature. If you feel that the auto response
feature is not working properly, adjust the response feature manually. This feature is available in
the following conditions:
• AUTO, NAV, and WIND modes
[Sea State] is set for [Full-Auto] or [Semi-Auto]
Auto response feature
Manual response feature
How to use the preset turns
The [Z
] key provides various
turnings, motions.
P: to "port"
S: to "starboard"
nen
1800 Turn
Orbit Turn
Troubleshooting
Control unit display is blank.
- Check power source.
- Check fuse Fl in processor unit.
Drive unit steers helm hard
Auto is activated.
- Drive phase set incorrectly.
Do rudder limit setup and rudder test on
Dockside setup menu, in Installation
How to dodge boats, obstacles
or
Release after object
has been dodged.
Response
PUSh ENTER kno
To return
Select [Auto]
Response
Auto 0 3
Turn the knob
to change value
Set response level.
3600 Turn
Spiral Turn
NAVpiIot
-No position data.
Check that position source is outputting
data.
over when
Displayed
agree with vessel
- Compass
menu. Do compass setup in Sea trial menu, in
Installation
O eration in the safe
Turn
to dodge object.
Raise the response level to get
back
interference (wind, etc.) is pushing
the boat
User Turn
(Default setting: 450 Turn)
00
Figure 8 Turn
does not auto advance.
compass heading does not
compass.
not calibrated.
menu.
helm mode
the helm
on course when external
off course.
(Deo
Circle Turn
Square Turn Zigzag Turn
How to display
Installation
this
On the STBY display,
press the ENTER knob
three times while
pushing[Z]
s
menu:
key