Generic RAMJOY RVS-050 Bedienungsanleitung Seite 64

FCCCompliance Statement
This device complies with Part 15 of the FCCRules.Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2)this device must accept any interference received, including 'nterference that may
cause undesired operation.
This device complies with Part 15 of the FCCrules and Industry Canada license-ex
empt RSS standard(s). Operation is subject to the following two conditions: (1)this
device may not cause harmful interference, and (2)this device must accept any
interference received, including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TVinterference caused by
unauthorized modifications or change to this equipment. Such modifications or
change could void the user'sauthority to operate the equipment.
This radio transmitter (identify the device by certification number or model number
if Category ) has been approved by ndustry Canada to operate with the antenna
types listed below with the maximum permissible gain indicated. Antenna types not
included in this list, having a gain greater than the maximum gain indicated for that
type, are strictly prohibited for use with this device.
This equipment has been tested and found to comply with the limits for a ClassB
digital device, pursuant to part 15 of the FCCRules. hese limits are designed to
provide reasonab e protection against harmful interference in a residential
installation. This equipment generates,uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more Ofthe following measures:
Reorient or relocate the receiving antenna.
ncreasethe separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RFexposure requirement.
TOmaintain compliance with FCC'sRFexposure guidelines, this equipment should
be installed and operated with a minimum distance of 20cm between the radiator
and your body