Specifications - Generic Ramjoy Rvs-050 Bedienungsanleitung

Does not seal after
1. Check whether the bag is damaged and cause air leakage;whether the bag is
correctly placed in the vacuum cavity; whether there are obstructions on the sealing
tape and the upper and lower sealing sponge.
2. Makesure that the heating strip and sealing sponge are not deformed or
damaged.
Air is still in the bag:
1. Ensurethat the whole open end Ofthe bag is inserted smoothly into the vacuum
channel entrance.
2. Examinethe bag for leaks.
3. f you are using a custom-sized bag, check the bag's seal.A 'wrinkle in the bag
along the seal may cause leakageand allow air to re enter. Just cut the bag and
reseal.
4. Do not attempt to make your own side seams for a bag. The bagsare manufac
tured vv•thspecial side seams, which are sealed all the way to the outer edge.
Making your own side seams may cause leakageand allow air to re-enter.
5. f you are using external mode, make sure the accessoryhose is inserted into the
accessory port.

Specifications

Model
Voltage
Rated Frequency
Power
Vacuum Degree
Maximum Seal Width
vacuum
RVS 050
120VAC
60HZ
- 50kPa
300mm (11.81inch)
09
EN