Digitus DN-80116 Gebrauchsanleitung

DIGITUS@
GIGABIT FIBER OPTIC SWITCH,
8 PORT SFP, 2 PORT RJ 45 UPLINK
Manual
DN-80116
1. Brief Introduction
The DIGITUS@Gigabit fiber switch provides 8 fiber SFP ports and 2 RJ45
uplink ports with Gigabit bandwidth. Low cost of ownership, ease of use
and high performance are the strengths of this fiber switch. The switch is
designed for FTTX applications, such as FTTN, FTTC, FTTB, FTTD or FTTH,
where the main areas of application are fiber optic LAN, industrial Ethernet,
distributed control systems and digital video surveillance. The switch can be
used in campus networks, in remote LAN extensions,
distributions, as well as in the ISP backbone area. The optical
be exchanged during operation (hot swappable). This cost-effective switch
offers a network layout that simplifies the installation
points and IP-based surveillance cameras
networks. It can be mounted as a 19" rack in server racks (IU) or as a
desktop switch. It provides the ideal networking
and intelligent LAN fiber access.
2. Packing list
Please check the following items in the package before installing the Fiber
Switch:
2RJ45 + 8SFP Fiber Switch 1 piece
Power cord 1 piece
User manual 1 copy
The Panels and LED indicators
3.
280
Mark
GI-G2
G3-GIO
Metro Ethernet
1000M
modules can
of wireless access
in commercial or private
solution for workgroups
LINK/ACT
G3-GIO
RESET
Installation
4.
4.1 Installation Warnings
Before cleaning the switch, unplug the power plug of the switch first.
Do not clean the switch with wet cloth or liquid;
Do not place the switch near water or any damp area. Prevent water or
moisture from entering the switch chassis;
Do not place the switch on an unstable case or desk. The switch might
be damaged severely in case of a fall;
Ensure proper ventilation
ventilation
Make sure that the operating voltage is the same one labeled on the
switch;
45
Do not open the chassis while the switch is operating or when electrical
hazards are present to avoid electrical shocks.
4.2 Installation
RJ-45 interface: Attach a CAT5 UTP cable from the 10/100/1000
160
T network to the RJ-45 port on the switch.
Fiber
fiber
Connect the power adapter and verify that the LEDlights on.
The TX Link and FX Link LEDsshould light when all cables are attached.
Name Function
Power Supply "On": Power is on and normal
Copper cable connector
RJ45 Port
Fiber Port "On": Fiber link is correct
Ethernet Rate
"On": 1000Mbps, "Off": 100Mbps
Indicators
"On": Ethernet link is in correct
connection
Ethernet Link
"Blink": Signal packet goes through
"On": Fiber link is in correct
Fiber LED
connection
indicators
"Blink": Signal packet goes through
Reset Switch When pressing, reactivate the switch
of the equipment room and keep the
vents of the switch free of obstruction;
interface: Attach a fiber cable from the converter
network.
connection
Base-
to the 1000M