Tascam MM-2D-E Bedienungsanleitung Seite 13

Using Dante Controller
Dante Controller
This unit uses the Dante Controller application, which is
available at the Audinate website, to connect with other de-
vices that support Dante.
Download the latest version Of the Dante Controller appli-
cation and an operation manual from the Audinate website.
Audinate download
https://www.audinate.com/products/software/dan-
te-controller
Make at least the following settings using a computer that
has Dante Controller installed.
Adjust the sampling frequency and bit depth of each
Dante device.
Set the audio routing.
NOTE
Settings made using Dante Controller are stored in the
built-in memory of each Dante device.
Unless settings are modified, connections will not change
even if Dante Controller is quit or the computer is discon-
nected from the Dante network.
overview
page
Audio routing settings
When Dante Controller is launched,
screen shown below will open.
On this screen, you can set and monitor conditions related
to the Dante network.
Dare Control'er • Network View
Dante
Filter
1
2
Receiving device name
This is the name of a receiving device on the Dante net-
work.
@ Receiving device channels
These are the names of the channels of the receiving de-
vice on the Dante network.
@Transmitting device name
This is the name of a transmitting device on the Dante
network.
@Transmitting device channels
These are the names of the channels of the transmitting
device on the Dante network.
(S)Audio routing
Route the audio channels of the transmitting and receiv-
ing devices that you want to connect here.
Left-click the intersection of the channels you want to
connect on the matrix to connect
NOTE
While pressing the computer keyboard Ctrl key, left-click
the at the intersection
connectable channels at once.
TASCAM MM-2D-E / MM-2D-X 13
the Network View
them.
of device names to connect
3
4
5
all