Tascam MM-2D-E Bedienungsanleitung Seite 12

Application overview
Using the TASCAM DCP CONNECT remote control applica-
tion, you can operate the unit from a distance.
For details about the application, please see its Owner's
Manual.
You can download the application Owner's Manual from
the TEACGlobal Site (http://teac-global.com/).
INPUT
Notes about Dante
Dante is a transmission protocol developed by Audinate.
Using networks based on gigabit Ethernet standards, it en-
ables multichannel (512 IN/512 OUT) transmission and high
precision, for example.
Check the Audinate website
https://www.audinate.com/
12 TASCAM MM-2D-E/ MM-2D-X
screen
for details about Dante.
Connecting to a Dante network
In order to set up and use this card, you must also set up the
Ethernet network that it is connected to, a computer that
runs Dante Controller and other devices that support Dante.
Requirements for LAN cables used for con-
nections with the connectors
Use STPcables that are at least category 5e.
Both crossover and straight cables can be used.
ATTENTION
This unit is not compatible with 100Mbps Ethernet
switching hubs. Always use switching hubs that support
Layer 2 and Gigabit Ethernet.
NOTE
• Set the computer to set the IPaddress automatically.
• Restarting the computer might be necessary if a previ-
ous network setting is still active on the computer.
Switched (daisy chain) connection
Dante devices can be daisy-chained when there are few
connected devices and when not using a switching hub.
Connect them as shown below.
Switched (daisy chain) connection example
Mixer
NOTE
• When using a switched (daisy chain) connection, either
DATA or DATA+PoE connectors
• Ifthe number of connected devices increases, raising the
latency setting will be necessary.
on this unit
MM-2D MM-2D
can be used.