Safety Notes; Intended Application; Operating Conditions - Noding Pm63 Betriebsanleitung

PM63
Betriebsanleitung Digital-Kontaktmanometer
Operating Instructions Digital Contact Pressure Gauge

SAFETY NOTES

If the device is used incorrectly, application related dangers may arise. The pressure gauge must be installed, connected,
commissioned, operated and maintained by qualified and authorised personnel only and under strict observance of these
operating instructions, relevant national standards, legal requirements, and where appropriate, the product certification.
INSTALLATION
The function of the pressure gauge is nearly independent of its orientation. To protect the process connection and pressure
diaphragm from damage, remove the protective cap just before installation. The device must be installed in accordance with
applicable national guidelines for pressure components. During installation, ensure that no water enters the housing.

INTENDED APPLICATION

The pressure gauge is designed for measuring absolute and gauge pressure of gases, vapours and liquids. Operation is only
intended according to the specifications stated on the product label.
CLEANING
The measuring device is maintenance-free.
Certain media can cause build-up and clogging of the sensor. Accumulated deposits can lead to incorrect measurements.
In the case of media that tend to form deposits, the sensor must be cleaned regularly, for example with clear water.
Do not use sharp or hard tools or corrosive chemicals to clean the sensor.

OPERATING CONDITIONS

Surrounding temperature: -25...80 °C
Storage temperature: -40...85 °C
Medium temperature: -25...100 °C
Revision: 04 / 2024 A
Technische Änderungen vorbehalten
Subject to change without prior notice
Nöding Messtechnik GmbH • Oldenfelder Bogen 29 • D-22143 Hamburg, Germany • Tel.: +49 40 67 58 51 – 0
Fax: +49 40 67 58 51 – 49 • Internet: www.noeding-messtechnik.de • E-mail: info@noeding-messtechnik.de