Doss Extreme Boom Schnellstartanleitung Seite 3

7. Bluetooth mode
1. Enable the Bluetooth feature on your device.
2. Select Extreme Boom on the Bluetooth list.
3. Once paired, you can see the status "connected" on your device.
Press to re-enter Bluetooth pairing if your device can't find Extreme
●
Boom in 10 secs.
8. TWS (True Wireless Stereo) mode
1. Press and hold
2. Once paired, the LED of the primary speaker turns solid white, while the
secondary speaker flashes in white.
3. Find "Extreme Boom" on your Bluetooth device and connect it.
9. Use your speaker with Echo Dot
You can connect the Dot with the speaker by Bluetooth.
Please follow the steps to set up via Bluetooth:
1. Download the Alexa app and follow the standard setup procedure to get the
dot connected to your home Wi-Fi network.
2. Switch the Extreme Boom to Bluetooth mode, you can press and hold the
Bluetooth button to keep it in pairing status.
3. Run the Alexa App, tap Menu, and then tap Settings.
4. Tap the Echo Dot in your list of Alexa devices, then tap Bluetooth.
5. The Extreme Boom should appear in the list of Bluetooth devices. If not,
please long press the Bluetooth button and try it again.
6. Once listed, tap on the speaker to complete the pairing process.
7. To remove the device, return to Bluetooth > tap the name of speaker > tap
"Forget Device"
Note:
Voice command will not be able to turn on/off the speaker if you connect to it via Bluetooth.
10. Safety instructions
Avoid dropping or hitting the speaker.
Avoid exposing to extreme temperature.
Avoid using the speaker near a microwave.
Never disassemble or repair the speaker.
Never use any corrosive cleanser/oil to clean.
Never leave the speaker in a car parked in the sun.
Never attempt to charge the speaker while it is wet.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.This device
complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
on both Extreme Boom to enter into TWS pairing.