Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Phottix'
Photography Specialists
Attaching
the Sun Shield
1. Align the tabs on the bottom of the Sun Shield with
the holes
on the front
2. When aligned, insert the tabs into the holes.
3. Slide the Sun Shield slightly to the left to disengage
the tabs.
4. Pressgently on the top Ofthe Sun Shield, towards the
bottom of the LCD,until it locks into place with a click.
Setting
Video Source
You must select the video input source when using the
Hector
7HD.
1. Press the Source
button
AV input modes.
2. The selection will appear in the upper right of the LCD.
Leave the selection highlighted
automatically switch to that input source.
Connecting
by HDMI, AV Cables
1. Turn
off the
Hector
7HD and camera.
2. Insert the cable into the appropriate port located on
back
Of the Hector
7HD.
3. Attach
the cable
to the camera.
Of the Hector
7HD.
to switch
between
HDMI
- the Hector 7HD will
4. Turn
on the camera
5. Select
the video
6. Engage Live View Mode on the camera.
Using the HDMI Out Port
The
HDMI
Out
Port
HDMI cable to be added. The cable from this port Will
carry the original camera signal to another display or
device.
using the Cable Clamp
The Cable Clamp on the back of the Hector 7HD will allow
multi-sized HDMI cables using right-angle connectors to
and
be fastened
to the
1. Unscrew and remove the bolt and cable faceplate.
2.Thread the cables through the grooves on the back Of
the Cable Clamp area.
3. Align the Bolt and Faceplate and screw back into place.
Connecting a Phottix Accessory Cable
Phottix Accessory Cables will connect a camera to the
Hector 7HD and give
1. Turn
off the Hector
and
Hector
7HD.
source.
on
the
Hector
7HD
back
of the
7HD.
and shutter release functions.
7HD and camera.
allow
another
Werbung
