Maintenance And Care - Lippert R-Wave Installations- Und Gebrauchsanleitung

USE AND DRIVING
• Be careful when opening the rear doors; bear in mind the space taken by the accessory and the
load carried.
• After fitting the load devices, drive at moderate speeds and be especially careful when
accelerating, braking and cornering. The effect caused by wind, sudden braking, sharp bends,
bumps and potholes are factors that compromise driveability.
• Never exceed speed limits and always observe the highway code. Always adapt speed to the
conditions of the road surface, traffic, weather conditions and the load being carried.
• Tackle speed bumps at no more than 15 km/h (9 mph).
• Be careful before washing the vehicle using automatic systems; remove the accessory if
necessary.

MAINTENANCE AND CARE

• Belts, bolts, etc., as well as wear parts may get damaged over time and so they must be
replaced. Lubricate adjustment screws and bolts regularly to extend the life of the accessory.
Wash the fabric parts regularly, in order to remove dirt and/or saltiness following use.
• If the accessory is accidentally dropped, immediately check that there are no damages such as
cracks or noticeable dents that may affect the correct functioning of the accessory. If this is the
case, replace the damaged part or the whole accessory.
• The product must be regularly cleaned with hot water and a neutral pH soap. Wipe dry with a
cloth. Avoid contact with aggressive chemical agents (e.g., solvents).
• Avoid falls.
LIABILITIES
As the owner of the vehicle, you are fully responsible for your safety and the safety of the people
being transported. The manufacturer shall not be held liable for any harm to property or persons
caused by having incorrectly assembled the accessory, by excessive speed or driving not respecting
weather, traffic and road conditions. Whenever another driver uses your car with the accessory fitted,
inform him/her of these warnings so that he/she is fully aware of them. The manufacturer is not liable
for damage to property or injury to people that may occur while the accessory is being installed.
DISPOSAL
• Eco-friendly disposal of both product and packaging is recommended. Sort out the different
materials for recycling, as set out and required by local regulations.
• Preferably dispose of this item through a waste disposal company; ask your local competent office
in case further information is needed in this regard.
• Be sure to comply with all regulations currently in force in your country.
29
CCD-0008073