Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.
When setting the repeat period, select as follows:
M-F: From Monday to Friday
S-S: From Saturday to Sunday
: From Monday to Sunday
6.
The snooze time can be set from 1 to 30 minutes or OFF, if "OFF" is selected, this means
the snooze function is turned off.
7.
The Alarm2 time can be set in the same way.
NOTES :
- If there is no valid operation within 20 seconds, it will automatically return to normal
time mode from the alarm time set mode.
- When adjusting the value, press and hold "+" or "–" for quick setting
- The Alarm will ring for 2 minutes if you do not deactivate it by pressing any button.
Turning OFF the alarm
•
When it's ringing, press any button except the "SNOOZE" button to turn off the Alarm.
•
When it's ringing, press and hold the "SNOOZE" button for 2 seconds to stop the Alarm.
When it's ringing, touch the "SNOOZE" button once. A sound indicates snooze mode. When
the set snooze time has elapsed, it will ring again.
RF Transmission Procedure
1.
The main unit automatically starts receiving transmission from remote sensor for
temperature & humidity after batteries have been inserted.
2.
The remote sensor will automatically transmit temperature and humidity data to the main
unit after batteries have been inserted.
3.
If the main unit failed to receive transmission from remote sensor ("- -.-" and "--" display
on the LCD), press and hold "CH" for 2 seconds.
rescanning the channel launch signal.
4.
The main unit can receive remote signals from up to 3 channels. Press "CH" to switch
and display data of different channels. When the symbol
channels will be displayed automatically every 5 seconds.
1.
When the temperature and humidity are shown in the LCD, the main unit starts recording
maximum and minimum temperature/humidity values.
2.
Press "+" and the LCD will display maximum temperature/ humidity value. When the
maximum value is displayed, press "+" again to display the minimum temperature /
humidity value.
3.
At the same time, "MAX" or "MIN" will be displayed on the LCD.
4.
The maximum/minimum values will be reset if you press and hold "+" for 3 seconds.
5.
The recorded values of the day will be automatically cleared at 0:00 every night.
Background lighting
•
When the USB-C cable is used for power supply, press
brightness.
•
After the backlight is dimmed, press "
backlight for 15 seconds.
icon will flash, the main unit will start
" once to switch to the brightest
- EN 28 -
appears, the data of different
to adjust the backlight
Werbung
