Connecting The Touch Module - Benq Rp6504 Bedienungsanleitung

Connecting the touch module

The touch module of the display supports easy plug-and-play operation. There is no need to
install additional drivers on the computer.
Try either method below to set up the video and touch input:
A
A. Connect the TYPE-C port on the display to a USB Type-C port on the computer using the
supplied USB Type-C cable.
B. Connect a video cable (HDMI/IN/VGA) and the supplied touch USB cable from a computer
to the corresponding ports of the display.
• HDMI must be used with the TOUCH at the front panel.
• HDMI 1 or HDMI 2 must be used with TOUCH 1.
• HDMI 3, VGA or IN(DP) must be used with TOUCH 2.
• Avoid blocking the touch screen frame (where sensors are located) when initiating the touch module.
• If any ghost image occurs, please try to un-plug and then re-plug all USB cables. If the failure image still
exists, use another USB Type-B to Type-A cable.
• It is highly recommended that you connect the display to the PC or laptop directly. Please be noted that
using a faceplate device or an extender may cause failures in touch operations since the display quality can
be affected by many uncertainties such as cable grade, cable quality, source and destination equipment, RF
and electrical interference, and cable patches.
B1
B2
+
or
or
A
B3
15