Using Touch Pen To Launch Ezwrite - Benq Rp6504 Bedienungsanleitung

Pairing remote control and the USB receiver
If you are experiencing issues using the function key on the remote control, please follow the
steps and pair again the remote control to resolve the issue:
1. Insert the USB receiver to Interactive Flat Panel's USB port and place the remote control
near it.
2. Press the and BLANK at the same time, and the indicator light will start flashing.
3. The pairing is completed once the indicator stops flashing.
Remote control usage tips
• Avoid getting the remote control wet or store it in humid environments (like bathrooms).
• If the display's remote control sensor window is exposed to direct sunlight or strong light, the
remote control may not operate properly. In this situation, change the light source, readjust
the angle of the display, or operate the remote control from a location closer to display's
remote control sensor window.

Using touch pen to launch EZWrite

Tap the thick tip of the touch pen on the display's NFC sensor to launch EZWrite. Note that the
horizontal and vertical angle should be less than 30 degrees.
30 °
13
30 °