Name Of Parts; Switch Setting; Cable Compensation Switch; Internal Dip Switch - Ikegami Rsu-871 Bedienungsanleitung

4. Name of parts

RS-232C CABLE
COMP.
our
6
5
O POWER switch
Used to tum on and off the power.
@ DC12V in terminal
Used to connect an extemal (DC12V) power supply.
(3) VIDEO IN connector
Connect to the video output of a camera.
@ VIDEO OUT connector
Connect to the video input of a monitor or VCR.
6) CABLE COMP.switch
This is for a cable compensation amplifier.
@ RS-232Cconnector
Used for an RS-232C interface.
C) Indicator
It indicates Power-On or communication
@ Lock screw
Remove the 4 screws to open the case and set the DIP switches.
@ Intemal DIPswitch (Inside of case)
Used to select camera type and baud rate.
VIDE
DC12V IN
+ OFF
o
1
IN
3
error.

5. Switch Setting

5-1. Cable Compensation
Set the switch according to the cable length between the RSU-871 and a camera.
witch position
Cable
3C-2V (RG-59/U) Less than 125m (410fi)
5C-2V (RG-6/U)
Less than 250m (820ft)
5-2. Internal DIP Switch
The internal DIPswitch (SW3) is used to select the camera ype and an RS-232C communication
baud rate.
sw Function OFF (initial)
SW3-1 Camera type
ICD-870
SW3-2 9600 bps
Baud rate
Notes: I) Beforeyou will change the DIPswitch position,be sureto tum OFF the power.
2) The camera type will be selectedautomaticallyregardlessof the SW3-I position.
Only in case of communicationerror, the setting of SW3-I will be effective.
Switch
s
100m (325ft) - 250m (820fi)
200m (650ft) - 500m (1640ft)
ON Note
When the power is tumed On, a cam-
ICD-703
era type is identified automatically.
If a communicationerror happensof-
4800 bps
ten, chenge to 4800 bps.