Ventmatika RCW Bedienungsanleitung Seite 17

LT RU
2.
"Fan "Fa speeed"
"Stop" – the unit is stopped
"Low", "Medium", "High"
The speed of the supply and extraction motors of the units with EC
motors can be adjusted individually (see II.6.7 and II.6.8)
3.
"Set "Se temperature"
The desired supply or extracted air temperature can be set from 15
to 30 °C.
4.
"Me "Menu"
"Operation schedule"
"Date/Time"
"Alarm preview"
"Languages"
"Sensor preview"
"Additional"
5.
Ind Indica Indica ication ication tion
extrac ext extrac racted racted ted
or "Ex "Extracted
6.
Meaning Mea
If several error messages exists, they are interchanged (the fi rst mes-
sage is shown and then the next message is shown, etc.)
"NC" or "No connection" – no connection with the unit's control
board.
"Unfreezing" – activated unfreezing function for the plate heat
exchanger.
"Change fi lters" – clogged fi lters (signal from the pressure relay).
"DR fault" – fault of the moisture sensor
"Economic" – reduction of the speed without reaching the set tem-
perature.
"Stop input" – the unit is stopped from the external Stop input signal.
"Standby mode" –when the fast button "Run/Standby" function is
selected (see II.6.5.3)
"Boost" – when the fast button "Boost" function is selected (see
II.6.5.3) or the external "Boot" signal.
"Night cooling" – if the selected function is on (see II.6.5.1)
"High CO2 level" – allowed CO2 level is exceeded (see II.6.5.2)
"Battery low" – Battery of the FLEX panel should be replaced with
the new one.
7.
Cur Current
www.ventmatika.com
Downloaded from www.Manualslib.com
EN DE FR
– allows se selecting t g the
– other settings gs (see II.)
based based based on on on t the the he he setting setting setting o of t of t f f
air air air temperatur temperature: temperature: e: e: (see I (see I (see II.6.3. .3.1)
air temperatu ature"
of the additiona onal informa rmation
time and date is is displayed ( d
manuals search engine
he speed ed
the the he mai maintaine mai maintaine nta ined ined d s supp supp upply upply ly or or or or
"Suppl pply air ir temper peratu ature"
line ine
(see II.2) .2)
Manual
Fan speed middle
Set temperature low
Supply air temp. Stop
Deicing
7:28 2013-06-04
Fan speed low
Set temperature 20 °C
Menu 19 °C
Supply air temp. 18 °C
Deicing
7:28 2013-06-04
Fan speed low
Set temperature 19 °C
Menu
Supply air temp.
Deicing
7:28 2013-06-04
Fan speed
Set temperature 19 °C
Menu
Supply air temp. 18.7 °C
No connection
7:28 2013-06-04
System NC
Date – Time
View Alarms
Languages
View sensors
Extra
Sun.
Sun.
Sun.
low
Sun.
6/7
17