Exchange Of The Flexible Shaft - Eberth Pt1-R760 Bedienungsanleitung

3.2.2. Exchange of the flexible shaft

Note: Make sure that the mains plug is disconnected before you start to change the shaft!
1. Bring the handle to the O position.
2. Pull out the shaft to expose the connector.
3. Loosen the M4 threaded screw with an Allen wrench and remove the shaft (Fig. 8).
4. Then mount the new shaft and fasten it with the M4 threaded screw and an Allen wrench.
5. Push the shaft back into the device opening by hand.
Do not start the tool! The exposed shaft may cause injury or damage to the device.
Figure 8
EN 7