Operation; Before Commissioning; Annular Jaw; Rotation Speed - Eberth Pt1-R760 Bedienungsanleitung

3. Operation

3.1. Before commissioning

•
Make sure the power plug is unplugged and is not damaged.
•
Check if the waterproof plug of the drum is installed.
•
Check for any damaged parts that could endanger your safety.
•
Lubricate the flexible shaft according to the instruction manual (4.1.1.).
•
The use of suitable accessories can improve the quality and efficiency of work.
•
Clean the dirt on the handle and on the machine body before use.
•
Check if the flexible shaft is worn or damaged. For worn flat, corrosion and bending deformations, the
shaft must be replaced.

3.1.1 Annular jaw

Turn the circlip anti-clockwise to set the flexible shaft and attachment in a "rigid" condition. In this
state, the shaft has more tension and can thus, easier to solve soiling and blockages. Turn the circlip
clockwise to release the shaft and make it easier to move back and forth.
NOTE: If the extended length of the flexible shaft is less than 200 mm or greater than 6000 mm, the
circlip must not be locked.
Figure 2

3.1.2. Rotation speed

You control the rotational speed between 0 and 560 rpm by the pressure intensity on the trigger. The
higher the pressure, the higher the speed.
EN 4