EDIFIER S360DB Schnellstartanleitung Seite 7

Connections
Manually re-pair the subwoofer and satellite speaker
The active satellite speaker has been paired with the subwoofer at the factory before shipment.
After powered on, they will reconnect automatically and the indicator on the rear panel of the
subwoofer will light in solid red. If the wireless connection fails to resume, follow the steps below
for manual pairing.
1. Power on the active satellite speaker, and then press and hold the "Pair" button on its rear
panel for 2 seconds.
2. Press and hold the "Pair" button on the rear panel of the subwoofer for 2 seconds. The red
indicator on its rear panel will blink rapidly.
3. Wait until the red indicator on the rear panel of the subwoofer is lit constantly. Then the
pairing is complete and wireless connection is established.
Note: If the red indicator on the rear panel of the subwoofer is in a breathing pattern, it indicates
that the subwoofer is disconnected and enters standby mode. Repeat the above steps.
•LED indicator blinks in a breathing pattern: subwoofer is disconnected and enters into standby
mode
•LED indicator blinks rapidly: subwoofer enters into pairing mode
•LED indicator is constantly lit: subwoofer is connected and operates normally