Electrical Safety; Safety Instructions - Lentz Rfc-1911 Bedienungsanleitung

IMPORTANT INFORMATION
BEFORE USE
Read the operating instructions and
safety instructions carefully before
using the device!
• Failure to observe the operating
instructions may result in serious injury or
damage to the device.
• Keep the operating instructions for
further use.
• If you pass the device on to third parties,
be sure to include these operating
instructions.
• The device is designed for private house-
hold use only and not for commercial use.
• Only use the device indoors and not
outdoors.

ELECTRICAL SAFETY

The hair clipper should only
•
be continuously operated for
a maximum of 90 minutes in
order to prevent its motor from
overheating. You can resume
using it after a 10-minute break.
The device is designed for clip-
•
ping dry hair: do not use it for
clipping wet and soppy hair.
The adapter may normally be-
•
come warm during charging.
Do not leave the device con-
•
nected to the adapter if it is not
plugged in. That can lead to the
adapter discharging the battery.
The manufacturer reserves the
•
right to make additional mod-
ifications to the hair clipper's
design.
8
EN

SAFETY INSTRUCTIONS

WARNING!
Do not use it for any purpose other
than that for which it is intended.
Follow the "Usage" instructions
below.
The hair clipper is intended
•
for operation from the power
source, the performance of
which is specified in the manual.
Do not leave the device running.
•
Switch the device off before you
lay it down.
The device is not intended for
•
use by people (including children)
with reduced physical, sensory or
mental ability, or if they have no
experience or knowledge, insofar
as they are not under supervi-
sion or have not been instructed
on using the device by the per-
son responsible for their safety.
In order to reduce the risk of fire
•
or electric injury:
- store the unused device un-
plugged;
- do not use the device in wet
areas;
- do not plug in the device if
there is water on its surface;
- do not insert and remove the
plug from the socket with wet
hands;
- avoid plug overheating by
ensuring it is tightly and fully
inserted in the socket;
- do not use the device if the
power cord is damaged or wet;
- unplug the device prior to
cleaning;
- never jerk the power cord to
switch off the device – remove
the plug from the socket care-
fully;