Before First Use - Lentz Rfc-1911 Bedienungsanleitung

Blade Oiling Indicator
When the running time reaches 30 min., this
indicator will start to blink every 0.5 seconds
to remind you that the blade needs to be
oiled. This indicator will disappear once you
restart the device.

BEFORE FIRST USE

CAUTION:
Packaging material is not a child's
toy. Children must not play with
the plastic bags. There is a risk of
suffocation.
• Remove all parts from the packaging
and remove all packaging materials. Also
remove any transport locks.
• Check the scope of delivery for complete-
ness and damage and clean the unit.
• Do not operate the unit if there is visible
damage to the unit or the connection cable.
CHARGING
1. Please fully charge the trimmer before
your first use or after a long period of not
using it.
2. When the battery lowers to 5%, the plug
symbol will blink to remind you to charge
the device.
3. Before and during charging, please make
sure the device is switched off.
4. There are 2 different ways to charge the
device:
With the charging stand: place the
device in the stand and then connect the
stand to the socket.
Without the charging stand: plug the
device directly into the socket.
5. The plug symbol will always light up in red
when connected to the power source.
6. It takes about 1.5 hours to fully charge the
device, and the battery power indicator
10
EN
will then read 100%.
7. After charging, please disconnect the device
with the adapter, and put away the adapter.
8. Do not leave the appliance plugged into
the wall socket for more than 24 hours.
HAIR CLIPPER OPERATION
1. Installing the required clipping attach-
ment. Only replace attachments when the
device is switched off. In order to discon-
nect the installed attachment, firmly press
the locking buttons simultaneously and
pull the attachment off. Then install a new
attachment in its place until you hear the
characteristic click.
2. Installing an attachment, if required. Only
replace attachments when the device is
switched off. The attachment should be
installed as follows: firstly, its front part
should be matched, and then the lock
in the rear part of the attachment by
lowering and snaping it on. If the lock of
the attachment does not fit the proper
place without effort, then its front part
is attached incorrectly. The attachment
should be removed in the reverse order
as follows: firstly, the lock in its rear part
should be disengaged, and then the at-
tachment can be completely removed.
3. In order to change the length for hair
shearing, you need to install one of the