Lentz RFC-1911 Bedienungsanleitung Seite 11

HOW TO CHOOSE THE PROPER ATTACHMEN
Beard
Neck
Whiskers
Ears
Eyebrows
Nose
Head hair
included attachments, with the required
value. The beard attachment moves with-
out a lock and it can be installed in one of
the four positions indicated at the side of
the attachment.
4. If you need a length exceeding 20 mm,
remove the attachment and use the
comb, or adjust the length with the fingers
of your free hand.
5. Set the switch into the I position and start
clipping. Change the attachments and clip-
pers only when the device is switched off.
6. First, take a small section of hair to get
used to the length of the hair being cut.
Start to clip from the occipitals and at the
sides, then clip in the front moving to the
crown. All your movements should be per-
Precise
trimmer



Nose
trimmer




formed against the hair growth direction.
7. Watch the speed of movement of the
device when clipping. The best results can
be achieved when the device moves with
its internal speed without being manually
accelerated.
8. The final treatment should be performed
without an attachment with light brushing
movements along the hair growth direc-
tion starting from the crown.
9. When you are done clipping, set the
switch to the 0 position.
Full-size
Razor
trimmer




EN 11