General Information; Installation Instructions/Safety Instructions Bruudt Holder For Rear Brake Fluid Reservoir For Yamaha R1 2009-2014 - Bruudt Rpbyam-R1 Anbauanleitung/Sicherheitshinweise

Thank you for choosing our products! We really appreciate your trust in our product and wish you a good and safe journey at
all times! Read these installation instructions carefully before installation.
1. ATTENTION : Important safety instructions: If you are not a trained mechanic, contact a specialist workshop to install this
product. Failure to follow the installation instructions can cause damage to your vehicle and void the warranty. No liability is
accepted for consequential damage. The manufacturer accepts no liability for damage caused by improper installation of this
BRUUDT product. Incorrect use of this product can impair driving safety. Unauthorized reworking and/or modification of the
product can lead to functional failure and is not permitted. Structural changes to the parts are not permitted and will lead to loss
of liability and warranty claims. Please keep these instructions for later use.
2. ATTENTION : All parts and connections that have been removed from the motorcycle must be reassembled in accordance
with the vehicle manufacturer's instructions or replaced with parts and connections supplied by us. Unless otherwise specified,
secure all threads with screw locking. Unless otherwise specified by the vehicle manufacturer or our company, all screws and
nuts must be tightened in accordance with DIN / ISO. After assembly, ensure that all previously removed parts and
connections have been properly reassembled.
3: ATTENTION : This product was developed for vehicles in their factory condition. Compatibility with original accessories or
accessories from other manufacturers cannot be guaranteed. If original accessories or accessories from other manufacturers
are used in addition, you should check the clearance, fit and possible collisions!
4.

GENERAL INFORMATION

carefully and ensure that all parts on the parts list are present and not damaged. Make sure that your vehicle is standing
securely and cannot fall over. Switch off the engine and remove the ignition key. If necessary, allow the engine/exhaust to cool
down. Disconnect the vehicle battery when working on the electrics. Make sure that you only use suitable tools. Have a second
person help you with the assembly work.
These instructions are written based on our current level of knowledge. We make no legal claims as to their accuracy. We
reserve the right to make technical changes.
Please note the order of the steps
5
Installation instructions/safety instructions
BRUUDT holder for rear brake fluid reservoir for Yamaha R1 2009-2014
Art.No .:
: Observe any country-specific regulations or TÜV regulations. Read the assembly instructions
RPBYam-R1