Werbung
EN
14
FIXING THE WATCH IN PLACE
55mm
60mm
This unique patent design is best match for different size of watch bracelet/wrist.
It can fit max. 58 mm watch diameter, the watch thickness is up to 20 mm and the
bracelet/ wrist diameter is limited from 35–62mm.
How to fix the watch in place
1
Remove the watch holder from the device by pulling the two tabs on the
side.
2
Close the strap or bracelet of your watch.
3
Compress the cuff, and slide your watch over the cuff, watch dial facing
outward.
4
Push the cuff into the drum until it locks into place, an audible click can be
heard.
Note: If the strap is too short, you can push out the detachable part at the
bottom at the bottom and then follow the steps to put the watch inside. Push
the cuff into the drum until it locks into place and an audible click is heard.
40mm
Part
removable
Werbung
