Ronix RP-0180 Bedienungsanleitung Seite 21

WARNING!
DO NOT ADJUST THE NOZZLE WHILE THE TRIGGER IS SQUEEZED.
RECOMMENDED CLEANINIG PROCEDURE
- Dissolve dirt by applying detergent with the fan jet to the dry surface.
on vertical surfaces, work from the bottom upwards. leave the detergent
to act for 1 to 2 minutes, but do not allow to dry out. Apply the high from
the surface, working from the bottom upwards.
Avoid allowing the rinsing water to run on to unwanted surfaces.
STORAGE
- Switch off the washer.
- Turn off the water supply tap.
- After use, the detergent residuals should be removed from the tank.
- Discharge residual pressure by pressing the trigger until no more water
comes out of the lance nozzle.
- Engage the gun safety lock.
- Remove the plug from the socket.
- Operate the washer with non-corrosive /non-toxic antifreeze before
storing for the winter.
WARNING!
BEFORE REUSING, COMPLETELY FLUSH THE UNIT OUT WISH
PLAIN WATER. ANTI-FREEZE CAN DAMAGE PAINTWORK SO YOU
MUST ENSURE THERE IS NO ANTI-FREEZE LEFT IN THE SYSTEM
BEFORE USING IT AGAIN.
MAINTENANCE
CAUTION:
Before working on the washer, disconnect the lug from the power supply
socket.
- to ensure good performance. check and clean the suction and detergent
19
9
User Manual