Ronix RP-0180 Bedienungsanleitung Seite 19

- Connect the water supply hose to female coupler. Then connect to
the water inlet of the washer. The supply hose must have an internal
diameter of at least 13mm (1/2 in) and must be reinforced. the water
supply must be at least equal to the washer delivery capacity.
OPERATION
- Turn on the water supply tap fully.
- Release the safety lock then press the trigger for a few seconds to
allow air to escape and dis charge residual pressure in the hose.
- Keeping the trigger pressed push the switch to start the motor.
- When re-starting the motor, always keep the trigger pressed.
17
User Manual