Siemens TK76K573 Gebrauchsanleitung Seite 41

The changes you have made
are saved automatically. It is
not necessary to confirm them
additionally.
The following setting options are available
to you:
> Language : Turn the knob
select the display language.
> Per-cup quantities
quantity can be set separately for each type
of drink and each cup size (see "Set per-
cup quantity" on page 42).
> Water hardness
(4) to select the required water hardness (1,
2, 3 or 4) (refer also to "Checking and
setting the water hardness").
> Coffee temperature
knob (4) to set the coffee temperature.
: Turn the knob
> Auto off after
to enter the time span after which the appli-
ance should automatically switch to "energy
saving mode" following the last drink prepa-
ration. A time between 5 minutes and 8
hours can be set. The default time is one
hour, but this can be shortened to save
energy.
: The display contrast can
> Contrast
be set from –20 to +20 with the rotary
knob (4). The default setting is 0.
: The lighting can be set
> Illumination
to , or
Off On Off after 5 min.
setting: ).
On
: Each time a new water
> Water filter
filter is inserted in the water tank (12), it
must be rinsed:
1. Place the water filter in the water tank
(12) and fill the tank with water up to the
"max" mark.
2. Turn the rotary knob
and press
Press start
(8).
3. Place a container with a capacity of 0.5
litres under the milk frother (10).
4. Press start stop (8). Water will now
run first through the filter to rinse it and
then into the container.
(4) to
: The per-cup
: Turn the knob
: Turn the
(4)
(factory
(4) to select
start stop
Empty the container. The appliance is
ready to use once more.
Rinsing the filter simultaneously activates
the setting for the Change filter
The filter is no longer effective when the
Change filter display appears, or at the
latest after two months. It needs to be
replaced for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance). Replacement filters
can be obtained from retailers or customer
service (see "Accessories").
After every filter change the filter must first
be rinsed. Proceed as described at the
beginning of this section.
If no new filter is used, turn the water filter
setting to .
Off
You can find detailed information about the
water filter in the enclosed filter instructions.
If the appliance has not been
used for a prolonged period
(e.g. during your vacation) the
filter should be rinsed before the
appliance is used again. To do
this, simply dispense a cup of hot
water.
Further entries in the Settings menu:
> Descaling program
descale the appliance, press
(8) and run the descaling programme
(see "Descaling").
> Cleaning program
clean the appliance, press
(8) and run the cleaning programme
(see "Cleaning").
: If you want to descale
> Calc'n'Clean
and clean the appliance at the same time,
press start stop (8) and run the
Calc'n'Clean programme
(see "Calc'n'Clean").
> Factory settings
your own settings and reset the factory
settings. To activate the factory settings,
press start stop (8).
en de
display.
: If you want to
start stop
: If you want to
start stop
: You can cancel
41