Hacker UAV-Control 20 Pro opto Montage- Und Betriebsanleitung Seite 6

- Betreiben Sie den Steller ausschließlich an geeigneten Akkus, niemals an einem Netzgerät.
Beschädigung oder Zerstörung von Steller oder Netzgeräten kann hier nicht ausgeschlossen
werden.
- Vergewissern Sie sich immer durch Reichweitentests von der einwandfreien Funktion der
Empfangsanlage in Ihrem Multikopter! Hier auch mit laufenden Motoren testen!
- Die Schutzabschaltungen des Stellers können nur im „normalen" Betrieb wirksam schützen.
Zum Beispiel bei Kurzschluss der Motorwicklung, der Kabel o.ä. kann der Steller trotzdem
beschädigt oder zerstört werden. Darum kontrollieren Sie bitte jedes Mal vor dem Betrieb alle
Kabel und Stecker auf einwandfreie Funktion.
- Bei Verpolung kann der Steller zerstört werden. Dies kann nachgewiesen werden und hier
erfolgt kein Ersatz auf Garantie.
- Mount the ESC low-vibration and shockproof in your multicopter. Be sure there is always
enough cooling for motor, ESC and battery. Zip ties are not a good method for mounting since
parts on the PCB can be damaged by pulling the ties to hard.
- Cables for battery connection can be summarized to a central point of power supply in the
multicopter. We recommend a power distribution board to allow a clean cable installation.
- Connect the servo plug of the ESC to the respective port of your FlightControl. There is no need
to teach min. and max. values. All ESCs are factory programmed to be used with all common
flightcontrols on the market.
- The motor is connected to the three cables using gold plated plugs or soldered directly. Polarity
makes no technical difference. In case of rotating in the wrong direction you can simply
exchange two plugs of the motor or program reverse direction. Caution: Luster terminals ect.
are no suitable connections.
- We recommend gold plated plugs only which have to be soldered correctly to the cables. Cables
to the battery should be as short as possible, maximum 15 cm long. Always pay attention for
correct polarity.
- Wrong polarity causes destruction of the ESC. Never connect the battery to the motor
connection cables, this will also destroy the ESC.
- Motor cables should be as short as possible but this length is not that critical. Longer cables
should be twisted. In any case the receiver unit should be mounted as far away as possible from
current carrying cables.
- Use this ESC with suitable batteries only. Never use a power supply unit.
- Always ensure perfect functionality of the receiving unit in your multicopter by doing a range
test. Also do this test with with running motors!
- The safety features of the ESC only can be useful in "normal" operation. A shortcut of the
winding or the wires for example the ESC also can be destroyed. Therefor check all cables an
connectors every time before use.
- Voltage reversal will destroy the ESC. This can be verified and there will be no warranty on.
Anleitung / Manual Hacker UAV Control
© 2013 Hacker Motor GmbH Seite 6