Set Turn-Off Delay; Create Programs; Key Lock - Witeg Wisd Rk Bedienungsanleitung

www.witeg.de
knob.
 In both cases is the speed during the shaking process variable. To change the SV you
only have to turn the Jog-Shuttle knob clockwise to increase the speed and counter-
clockwise to reduce it.
 To stop the stirring process manually, you have to push the Jog-Shuttle knob again or
decrease the speed till "0" by turning the Jog-Shuttle knob counter-clockwise.

6.3 Set turn-off delay

 The delay timer serves as automatically stop function. It turns off the process after the
timeframe you set is elapsed.
 To reach the timer menu you have to push the MODE button in the menu item "set
speed". The timer lamp is blinking.
 The delay time is adjustable from one minute till over 99 hours (00:01 - 99:59) in one
minute steps.
 Turn the Jog-Shuttle knob to set your delay time. Push the Jog-Shuttle if you reached
the desired value to confirm it. With the confirmation the timeframe starts elapsing.
 If you want to change the value after confirmation, you have to push the Jog-Shuttle
once again. The PV initiates blinking and you can modify the value again.
 To confirm the value push the Jog-Shuttle knob yet again.

6.4 Create programs

 If there is no delay time running and the platform stands still, you reach the menu item
"choose program" by pushing the MODE button in the menu "set turn-off delay".
 You can recognize this menu at "Pro" is showed on LCD an at the blinking program
lamp.
 Turn the Jog-Shuttle knob to choose the program you want to use.
 Hold the Jog-Shuttle pushed for two seconds to reach the menu "change program" for
modulation of the chosen program. "StP0" is showed on LCD now and means the first
step of the program.
 First you have to set the speed by turning the Jog-Shuttle. Push the MODE button to
probate and save the set value.
 Now you have to set the step duration by turning the Jog-Shuttle. Push the MODE
button to probate and save the set value and jump to the next step.
 In every step you have to set speed first and then the step duration afterwards.
 It is not possible to set durations of "0", the program will only run to the previous step
and stop there. But setting the speed "0" is possible.
 If you want to leave the program modulation you have to hold the Jog-Shuttle pushed for
two seconds again.
 Start and stop programs by short pushing of the Jog-Shuttle.
 There is a signal sound after the program's end.

6.5 Key lock

 To avoid accidental changing of the set values, push the MODE button in the menu item
"set turn-off delay" or in the menu "choose program" (have a look at the menu structure if
you are unsure).
 In this menu item can you see the actually speed in the SV-line and the remaining time
of delay function in the PV-line. The function of the Jog-Shuttle knob is deactivated.
witeg Labortechnik GmbH, RK-D Programmable Rocker
17